Lift-Off Oven Door; Probe - Monogram ZDP486NRPSS Manuel Du Propriétaire

Lift-off
oven door

Probe

49-85247
The door is very heavy. Be careful when removing and lifting the door.
Do not lift the door by the handle.
To remove the door:
1. Fully open the door.
2. Pull the hinge locks down toward the door
frame, to the unlocked position. A tool, such
as a small flat-blade screwdriver, may be
required.
3. Firmly grasp both sides of the door at the
top.
4. Close door to the door removal position,
(approximately 15 degrees from closed) and
lift it up and out until the hinge arm is clear
of the slot.
To replace the door:
1. Firmly grasp both sides of the door at the
top.
2. With the door at the same angle as the
removal position, seat the indentation of the
hinge arm into the bottom edge of the hinge
slot. The notch in the hinge arm must be
fully seated into the bottom of the slot.
3. Fully open the door. If the door will not fully
open, the indentation is not seated correctly
in the bottom edge of the slot.
4. Push the hinge locks up against the front
frame of the oven cavity, to the locked
position.
5. Close the oven door.
Allow the temperature probe to cool before
cleaning.
The probe should be cleaned with soap and
water by hand.
Do not immerse the temperature probe in
water.
Do not store the temperature probe in the
oven.
Do not clean the temperature probe in the self-
cleaning oven.
Care and Cleaning
Professional Dual Fuel Range
Slot
Hinge lock
Pull hinge locks down to unlock
Bottom
edge
of slot
Indentation
Hinge
arm
Hinge
lock
Push hinge locks up to lock
Removal
position
Replacement
position
Hinge arm
31