Prefl Ight; Transmitter Setup; Dual Rates - Horizon Hobby E-FLITE P-47 Thunderbolt Manuel D'utilisation

EN
Prefl ight
1 Remove and inspect contents.
2 Read this instruction manual thoroughly.
3 Charge the fl ight battery.
4 Setup Transmitter using transmitter setup chart.
5 Fully assemble the airplane.
6 Install the fl ight battery in the aircraft (once it has been fully charged).
7 Check the Center of Gravity (CG).
8 Bind the aircraft to your transmitter.
9 Make sure linkages move freely.

Transmitter Setup

IMPORTANT: After you set up your model, always rebind the transmitter and
receiver to set the desired failsafe positions.

Dual Rates

Take fi rst fl ights in Low Rate. For landings, use high rate elevator.
NOTICE: To ensure AS3X functions properly, do not lower rate values below
50%. If lower rates are desired, manually adjust the position of the pushrods
on the servo arm.
NOTICE: If oscillation occurs at high speed, refer to the Troubleshooting Guide
for more information.
Expo
Expo is factory set in the receiver. After fi rst fl ights, you may adjust expo in your
transmitter or refer to the AR636 receiver manual for expo adjustment.
4
10 Test the retract operation.
11 Test the fl ap operation.
12 Perform the Control Direction Test with the transmitter.
13 Perform the AS3X Control Direction Test with the aircraft.
14 Adjust fl ight controls and transmitter.
15 Perform a radio system Range Test.
16 Find a safe open area to fl y.
17 Plan fl ight for fl ying fi eld conditions.
Computerized Transmitter Setup
(DX6i, DX6, DX7, DX7S, DX8, DX9, DX10t and DX18)
Start all transmitter programming with a blank ACRO model (do a model
reset), then name the model.
HIGH 100%
Set Dual Rates to:
LOW 70%
Set Servo Travel to: 100%
1. Go to the SETUP LIST MENU
2. Set MODEL TYPE: ACRO
3. Set REVERSE: Gear Channel
DX6i
4. Go to ADJUST LIST MENU
Norm 100 Flap and 0 ELEV
5. Set FLAPS:
LAND 80 Flap and  10 ELEV
1. Go to the SYSTEM SETUP
2. Set MODEL TYPE: AIRPLANE
3. Set WING TYPE: 1 AIL 1 FLAP
4. Go to the FUNCTION LIST
5. Set SERVO SETUP: Reverse GEAR
DX7S
6. Set FLAP SYSTEM: Choose Flap
DX8
NORM: -100% FLAP and 0% ELEV
MID: -30% FLAP and -3% ELEV
LAND: 80% FLAP and -10% ELEV
SPEED 2.0S: SWITCH = FLAP
1. Go to the SYSTEM SETUP
2. Set MODEL TYPE: AIRPLANE
3. Set AICRAFT TYPE:
WING: 1 AIL 1 FLAP
DX6
4. Go to the FUNCTION LIST
DX7
5. Set SERVO SETUP: Reverse GEAR
DX9
6. Set FLAP SYSTEM:
DX10t
SELECT SWITCH D:
DX18
POS 0: -100% FLAP and 0% ELEV
POS 1: -30% FLAP and -3% ELEV
POS 2: 80% FLAP and -10% ELEV
SPEED 2.0