Displaying Values For Individual Laps; Faq (Frequently Asked Questions And Services) - Sigma SPORT PC 15.11 Mode D'emploi

7 TRAINING WITH LAPS

7.3.4 DISPLAYING VALUES FOR INDIVIDUAL LAPS

You can re-view the different measured values for the individual laps.
Prerequisite: Your heart rate monitor must be in training mode.
1 Hold down the LAP button until the lap view opens.
A value from the last lap is displayed.
2 Select a lap.
Press the LAP or the START/STOP button to scroll through
the laps.
3 Press the TOGGLE (-) or TOGGLE (+) button to view the
corresponding lap values.
4 Exit lap view.
Hold down the LAP button. The training mode is displayed.

7.4 FAQ (FREQUENTLY ASKED QUESTIONS AND SERVICES)

What happens if I remove the chest belt during training?
The watch will no longer receive a signal. The screen will indicate "O"
and after a short period of time the PC 15.11 will go into sleep mode.
Does the SIGMA heart rate monitor completely switch off?
No – only the time and date are displayed in sleep mode so that you can
also use the heart rate monitor as a normal watch. The PC 15.11 uses
very little power in this state.
66 www.sigmasport.com
7 TRAINING WITH LAPS
7.4 FAQ (FREQUENTLY ASKED QUESTIONS AND SERVICING)
The display responds sluggishly or shows a black coloration,
what is the reason for this?
The operating temperature may have been exceeded or fallen below.
Your heart rate monitor is designed for a temperature of 0°C to 55°C.
What should I do if the display is faint?
A faint display may be the result of a weak battery. The latter should be
replaced as soon as possible – battery type CR 2032 (ref. no. 00342).
Are SIGMA heart rate monitors waterproof and can they be used for
swimming?
Yes – the PC 15.11 is watertight up to 3 ATM (corresponds to a test
pressure of 3 bar). The PC 15.11 is suitable for swimming.
Please note: Do not press the buttons underwater as water can enter
the housing. Avoid using in sea water as malfunctions can occur.
67