Interrupting A Training Session; Ending A Training Session; Training Values After Training; Resetting The Training Values - Sigma SPORT PC 15.11 Mode D'emploi

6 TRAINING MODE

6.6 INTERRUPTING A TRAINING SESSION

You can pause and restart your training any time.
Press the START/STOP button. The stopwatch icon
disappears. The stopwatch stops.
Press the START/STOP button again. The stopwatch
icon reappears. The stopwatch restarts.

6.7 ENDING A TRAINING SESSION

You have finished your training run and also want to
end your training session on your heart rate monitor.
Press START/STOP button as soon as you want to
end your training. This prevents your average heart
rate or training time from being distorted.
Hold down the TOGGLE (-) button. You switch to
sleep mode. Only the time and date are displayed so
as to save the battery. The current training values
remain saved.
Note: If you have stopped training, your heart rate
monitor goes into sleep mode after five minutes.
60 www.sigmasport.com
6 TRAINING MODE

6.8 TRAINING VALUES AFTER TRAINING

Prerequisite: You must be in training mode.
After training, you can view the measured values in the training mode
at your leisure. Use the START/STOP, TOGGLE (-) and TOGGLE (+)
buttons to scroll through the individual values. In addition to the current
training values, the heart rate monitor also shows summed values such
as:
· Total time
· Total calories
Note: Total values are available only when the stopwatch is stopped.

6.9 RESETTING THE TRAINING VALUES

Before you begin a new training session, you should set the training
values to zero as the heart rate monitor will otherwise continue to count
the values. The summed total values for time and calories remain saved.
Prerequisite: You must be in training mode.
Press and hold the START/STOP button. The display
flashes twice and all values are reset. You will then
see the training mode again.
61