ESAB Air 160 Mode D'emploi page 5

GB
Discharging: For the intelligent battery (0701 416 203) fitted with a discharge function. This may be
activated by holding down the YELLOW button until the RED light starts flashing indicating discharging. After
discharging the charger will switch to normal charge and then to maintenance charge when ready. Dependent
on battery and state of charge the discharge function may take over 24hrs. Due to this it is recommended that
this is used approximately once every 3 months to maintain battery in optimum condition.
If the turbo unit is to be stored without use for more than 3 months the battery must be detached from the
turbo unit before storage.
Main filter
WARNING This Turbo unit offers NO protection unless a Main filter is fitted.
Care should be taken when handling filters.
Do not touch the pleated paper filter medium.
Do not use filters with damaged paper filter medium.
Do not use filters after their expiry date.
Do not use filters with no or damaged filter seal.
If after changing the pre-filter, the airflow indicator or electronic warning device still indicates low flow, the main
filter should be changed as detailed below.
Filters should be fitted as follows:
Remove the front cover by easing open the right hand side.
Fit the filter squarely into the turbo unit.
Place pre-filter over filter (if used).
Close the cover over the filter by pressing down on the centre of the cover until it snaps home, taking care that
the cover does not touch the filter media when being closed.
Do not attempt to clean the filters, once fully loaded they must be replaced.
Filters available:
Part Number Description
0700 002 018 TH2PSL Filter
0700 002 024 TH3PSL Filter
0700 002 041 TH2PSL Nuisance odour Filter
Pre-Filters
The pre-filter is available as an optional item, which sits in front of the main filter and removes coarse dust.
The nuisance odour pre-filter also removes nuisance odours.
Frequent changing of the pre-filter will maximise the life of the main filter.
The pre-filter should be changed regularly and immediately if the airflow indicator indicates low flow.
Pre-filters available:
Part Number Description
0700 002 023 Standard Pre-filter (pk5)
0700 002 040 Nuisance odour Pre-filter (pk10)
IRL
Usage
Removal of fine dust/fume particles.
Removal of fine dust/fume particles.
(high efficiency)
Removal of fine dust/fume particles dust
particles & Nuisance odours.
Colour Usage
White Removal of course dust particles.
Black Removal of course dust particles &
Nuisance odours.
4