Osd Menu; System - Comelit SPTZ10IR Mode D'emploi

 Angle Display Format: XXX.XX(pan)/XXX.XX(tilt)
 IR Display: ☀ means the IR is turned on.

4 OSD Menu

4.1 System

<MAIN MENU>
<SYSTEM>
<DOME>
<CAMERA>
<IR>
<DISPLAY>
<TIME>
<LANGUAGE>
<RESET>
EXIT
<SYSTEM>
PROTOCOL PELCO-D/P
COMM
DOME ID
MODULE
VERSION
<COMM SET>
EXIT
<COMM SET>
DEVICE ID
CHECK ID
TARGET ID
BAUDE RATE
SAVE
EXIT
this camera. It will be effective immediately after it is changed.
13
<SYSTEM>
 PROTOCOL: Displays the protocol of the dome.
 COMM: represents the communication Information; 2400 is
the baud rate, which can be changed via the DIP switches or
2400.N.8.1
software the available baud rates are: 1200, 2400, 4800 and
001
9600. "N.8.1" represents the Check bit,
bit.
 DOME ID: This is the address number of the dome. The
range is 000-255.
 MODULE: Displays the brand and model of the installed
camera module.
 VERSION: Displays the current operating system.
 <COMM SET>
 DEVICE ID: Used to distinguish this dome from the ID of
other domes.
 CHECK ID: distinguishing several domes with same ID and
altering TARGET ID, soft protocol and baud rate, need to
enter CHECK ID in line with the DEVICE ID, otherwise altering
can't be completed.
 TARGET ID: enter the new address you wish to assign to
means the IR output power.
Data bit and Start