Comelit AHPTZ110A Mode D'emploi page 26

① In Figure 1-5-3, move the rocker up and down so that the cursor points to delete all
privacy mask, and then move the rocker to the right to delete all privacy mask.
② In Figure 1-5-3, move the rocker up and down so that the cursor points to delete all
presets, and then move the rocker to the right to delete all presets.
③ In Figure 1-5-3, move the rocker up and down so that the cursor points to delete all
linear scans, and then move the rocker to the right to delete all linear scans.
④ In Figure 1-5-3, move the rocker up and down so that the cursor points to delete all
cruise scans, and then move the rocker to the right to delete all cruise scans.
⑤
In Figure 1-5-3, move the rocker up and down so that the cursor points to delete all
pattern scans, and then move the rocker to the right to delete all pattern scans.
⑥
In Figure 1-5-3, move the rocker up and down so that the cursor points to delete all
group scans, and then move the rocker to the right to delete all group scans.
⑦
In Figure 1-5-3, move the rocker up and down so that the cursor points to delete all
continuous scans, and then move the rocker to the right to delete all continuous scans.
⑧
In Figure 1-5-3, move the rocker up and down so that the cursor points to delete all
alarm settings, and then move the rocker to the right to delete all alarm settings.
⑨ In Figure 1-5-3, move the rocker up and down so that the cursor points to delete all the
timing settings, and then move the rocker to the right to delete all the timing settings.
1.5.2 System restart
In Figure 1-5-1, the cursor pointing system restart by moving the rocker up and down, and
then move the rocker to the right to restart the PTZ camera system. The PTZ camera checks
itself every 72 hours.
1.5.3 Restore factory settings
In Figure 1-5-1, move the rocker up and down to make the cursor point to restore factory
settings, and then move the rocker to the right to restore the factory settings. Note: After the
factory settings are restored, PTZ camera system parameters will be restored default values
and system data will be deleted.
26