Comelit AHPTZ110A Mode D'emploi page 12

③ Pattern scan settings: in Figure 1-2-3, move the rocker up and down to point the cursor
at pattern scan settings, and then move the rocker to the right to enter the pattern scan
settings menu, as shown in Figure 1-2-10.
Pattern scan
No.
Set pattern
Calling pattern
Delete current
Back
Exit
Figure 1-2-10
I No.: 1-4 optional. PTZ camera can set 4 groups pattern scan. Patterns scan realizes
recording and playback of arbitrary trajectory, and its recording parameters include
horizontal speed, vertical speed and zoom multiples. Each pattern can record 500
commands.
II In the menu of Figure 1-2-10, move the rocker up and down so that the cursor points
to the set pattern, and then move the rocker to the right to enter the set pattern state. Move
the rocker up and down and left and right to control the camera to rotate horizontally and
vertically, and change the camera magnification according to [WIDE], [TEIE]. The PTZ
camera records the trajectory of the camera and the camera zoom information in real time.
Press ［CLOSE］ to save the pattern scanning settings and return to the pattern scanning
settings menu.
III In Figure 1-2-10, move the rocker up and down to point the cursor at calling pattern,
then move the rocker to the right to run the pattern scan, and move the rocker arbitrarily
back to the pattern scan settings menu.
IV In Figure 1-2-10, move the rocker up and down so that the cursor points to delete
current pattern, and then move the rocker to the right to delete the current pattern scan.
④ Group scan settings: in Figure 1-2-3, move the rocker up and down so that the cursor
points to the group scan settings and then move the rocker to the right to enter the
group scan settings menu, as shown in Figure 1-2-11.
1
12