Comelit AHPTZ110A Mode D'emploi page 14

and down to select the required time interval. Move the rocket to the right to save the settings
and exits the selection status.
III In Figure 1-2-11, move the rocker up and down so that the cursor points to the calling
group then move the rocker to the right to run the group scan, and move the rocker
arbitrarily back to the group scan settings menu.
IV In Figure 1-2-11, move the rocker up and down so that the cursor points to delete the
current, and then move the rocker to the right to delete the current group scan.
⑤ Continuous scan settings: in Figure 1-2-3, move the rocker up and down to make the
cursor point to the continuous scan settings, and then move the rocker to the right to
enter the continuous scan settings menu, as shown in Figure 1-2-13.
Continuous scan
No.
Speed
Set continuous scan
Calling continuous scan
Delete current
Back
Exit
Figure 1-2-13
I No.: 1-4 optional. The PTZ camera can set four groups continuous scan. Continuous
scan realizes 360 degree horizontal continuous monitoring, in which the horizontal
movement speed can be set and the elevation angle can be set. After power failure, restart
the elevation angle before power failure.
II Speed: 1-10 optional, default is 9. 1 level is minimum speed, 10 level is maximum
speed.
III In the menu of Figure 1-2-13, move the rocker up and down to point cursor to
continuous scan settings, and then move the rocker to the right to enter setting continuous
scan status. Move the rocker up and down to control the vertical position of the camera.
Press ［CLOSE］ to save the Continuous Scan Settings and return to the Continuous
Scan Settings Menu.
IV In Figure 1-2-13, move the rocker up and down to make the cursor point to calling
continuous scan, then move the rocker to the right to run continuous scan, and move the
1
9
14