MINN KOTA 1355920 Mode D'emploi page 9

2
b. Deploy the motor and remove the Motor Assembly
from the Mount by loosening the Depth Adjustment
Knob and opening the Latch & Door.
3
c. Position the Mount again in the stowed position.
d. Temporarily remove the six Phillips Screws that
fasten the Motor Rest to the Mounting Bracket
and remove the Motor Rest to expose the motor
mounting hole pattern.
4
e. Determine the mounting hole pattern you wish to
use. Using the mounting holes in the mount as
your template, mark the top deck of the boat with a
pencil or similar marking tool.
f. Remove the Mount from the deck of the boat and
drill the holes that you marked in the previous step
using a 9/32" Drill Bit and Drill. Be careful not to
damage any wiring or critical features that may exist
under the surface you are drilling through.
g. Place the Mount on the deck of the boat again and
verify the Hold Down Strap is positioned 15 ¾" from
the front of the bow mount.
h. Fasten the mount to the deck of the boat using the
supplied 1/4" – 20 X 2" bolts, washers and nuts.
Tighten the stainless steel hardware securely but
slowly to the deck of the boat using a 7/16" box
end wrench.
©2021 Johnson Outdoors Marine Electronics, Inc.
Motor Assembly Motor Assembly
Motor Rest Motor Rest
Phillips Phillips
Screws Screws
Bow Bow
15 3/4" 15 3/4"
NOTICE:
To prevent seizing of the stainless steel hardware,
do not use high speed installation tools. Wetting the screws
or applying an anti-seize may help prevent seizing.
INSTALLATION
Latch & Latch &
Door Door
Depth Depth
Adjustment Adjustment
Knob Knob
Mounting Mounting
Bracket Bracket
Mounting Holes
Pattern 1 Pattern 1
Pattern 2 Pattern 2
Hold Down Strap Hold Down Strap
minnkotamotors.com | 9