Adjusting The Tiller - MINN KOTA VANTAGE 80 Manuel De L'utilisateur

USING & ADJUSTING THE MOTOR
BACKTROLLING
The orientation of the lower unit can be changed for backtrolling. Set your speed to 0 and trim the lower unit down to the fully
deployed position. Slide the latch knob to the front and hold. Align the directional indicator with the tiller handle and slightly twist
the indicator knob left or right while pulling up with slight force until the alignment is achieved and the indicator knob is free. Lift
and turn the indicator knob counterclockwise 180°, then align the indicator in its new position with the tiller handle and press
down to re-seat it. Release the latch knob..
Indicator Knob
Latch Knob
(shown in forward position)

ADJUSTING THE TILLER

Pull the tiller handle to extend the tiller an additional 7 inches.
Clamp Screw
The handle can be positioned at an angle using the large clamp screw.
Loosen the screw located at the base of the handle, adjust the handle
to a comfortable position then hand-tighten the screw.
CAUTION: Over-tightening the clamp screw, or adjusting
the handle angle without loosening clamp screw, can
damage the bracket.
NOTE: Always loosen clamp before adjusting angle and
retighten when desired angle is achieved.
12 | minnkotamotors.com
©2014 Johnson Outdoors Marine Electronics, Inc.