marklin Kof II Mode D'emploi page 24

➈
The new setting is acknowledged by
turning the speed control knob to the
left past the "0" position (reversing the
direction of travel). The locomotive
confirms the entry of the address,
when the headlights come on for
over 1 second. The locomotive's light
function then begins to blink.
➉
If you do not want to change any
other parameters, you end the pro-
gramming by entering the value "80"
on the 10-button keypad on the
Control Unit. You can also end the
procedure by pressing the "stop" but-
ton and then pressing the "go" button.
If you want to change other parame-
ters, then go to Step 6 (Selecting the
parameter) and carry out the steps
after it.
➈
10
1
➉
80
1
2
2
Operation
Tips:
G The parameters set at the factory
can be reproduced by entering the
value "08" in Step 6 and then
entering the value "08" again in
Step 8.
G Write down the values that you
have set for a locomotive.
25