Reassembling The Swingarm - MOTO GUZZI V1100 Mode D'emploi

TRANSMISSION
8.1.3

REASSEMBLING THE SWINGARM

•
Smear some grease all along the swingarm shaft.
•
Fit the ring nut on the swingarm shaft and tighten finger
tight.
• Working on either side, grease cardan joint grooves
with the recommended product, see (LUBRICANTS
TABLE).
•
Support the swingarm, fit the cardan joint, match the
holes and, simultaneously, fit the shaft completely with
the help of a second person.
•
Tighten the swingarm shaft.
NOTE Prepare the suitable special tool (OPT):
- guzzi part# 05.91.26.30 (tool for tightening swingarm
shaft ring nut).
• Tighten the ring nut using the suitable box spanner.
• Tighten the two screws on the swingarm clamp.
8 - 8
www.guzzitek.org + www.guzzitech.com - Revente Interdite - Revendita Vietata - Resaling Forbiden - Wiederverkauf Verboten
Griso V1100