Transmission Oil - MOTO GUZZI V1100 Mode D'emploi

GENERAL TECHNICAL INFORMATION
2.2.2

TRANSMISSION OIL

CHECKING AND TOPPING UP
•
Keep the vehicle upright with both wheels on the
ground.
• Unscrew and remove the level plug (1).
• The correct level is just below the hole of the level plug
(1).
•
If the oil is below the specified level,
LUBRICANT TABLE) until the level plug hole (1) is
reached.
WARNING
Do not add additives or other substances into
the fluid.
If you use a funnel or other tool, ensure it is
perfectly clean.
CHANGING ENGINE OIL
WARNING
Change oil when the unit is hot, as oil will be
more fluid and will drain more easily.
NOTE Letting the engine idle with the vehicle at standstill is
not the correct procedure to warm the engine and engine oil
up to operating temperature for an oil check. Oil is best
checked after taking a short ride; 15 Km (10 mi) will be
enough.
•
Place a container holding more than 400 cm3 (25 in
under the drain plug (3).
• Unscrew and remove the drain plug (3).
•
Unscrew and remove the breather plug (2).
•
Drain the oil into the container and let all remaining oil
drip out for several minutes.
• Check the sealing washer of the drain plug (3) and
replace it if worn.
•
Clean off any metal debris sticking to the drain plug (3)
magnet.
•
Refit the drain plug (3) and tighten.
•
Pour fresh engine oil in the inlet hole (1) - see
LUBRICANT TABLE - until the level reaches the hole
of the level plug (1).
WARNING
Do not add additives or other substances into
the fluid.
If you use a funnel or other tool, ensure it is
perfectly clean.
•
Refit and tighten the plugs (1 – 2).
2 - 20
www.guzzitek.org + www.guzzitech.com - Revente Interdite - Revendita Vietata - Resaling Forbiden - Wiederverkauf Verboten
top up (see
3
)
Griso V1100