MOTO GUZZI V1100 Mode D'emploi page 333

Griso V1100
•
Remove both pins.
•
Remove the vibration damper.
•
Remove one pad at a time.
WARNING
Do not operate the brake lever when the pads
are not in place or the calliper pistons might
come out of their housing, thus causing brake
fluid leakage.
•
Install two new pads, fit them so the holes match those
on the calliper.
WARNING
Always change both pads and ensure that they
are correctly in place inside the calliper.
•
Fit the vibration damper; remember that the arrow must
indicate the direction of travel.
• Insert both pins.
• Fit both split pins.
•
Pull the brake lever several times to take the pistons
against the pads.
•
Check the brake fluid level.
www.guzzitek.org + www.guzzitech.com - Revente Interdite - Revendita Vietata - Resaling Forbiden - Wiederverkauf Verboten
GENERAL TECHNICAL INFORMATION
2 - 27