MOTO GUZZI V1100 Mode D'emploi page 325

Griso V1100
•
Unscrew and remove the filler plug (3).
• Drain the oil into the container and let all remaining oil
drip out for several minutes.
•
Check the sealing washers of the drain plug (2) and
replace them if worn.
•
Clean off any metal debris sticking to the drain plug (2)
magnet.
• Refit the drain plug (2) and tighten.
• Fill with fresh engine oil (see LUBRICANT TABLE)
until the level is above the minimum mark MIN.
CHANGING THE ENGINE OIL FILTER
•
Using the suitable wrench, remove the engine oil filter
from its seat (unscrew).
NOTE Do not use filters that have already been used.
•
Smear some oil on the new oil filter seal.
•
Using the suitable wrench, fit and tighten the new oil
filter to the torque of 18 – 20 Nm.
www.guzzitek.org + www.guzzitech.com - Revente Interdite - Revendita Vietata - Resaling Forbiden - Wiederverkauf Verboten
GENERAL TECHNICAL INFORMATION
2 - 19