Topdon AL500B Manuel De L'utilisateur page 52

Battery Test Cable Length
Working Temp.
Storage Temp.
Dimensions
Weight
SECTION 13 FAQ
Q: The tool's system stops/freezes when reading data
stream. What should I do?
A: This may happen due to a loose connector. Please unplug
the connector and plug it in again.
Q: Why does the screen flash during ignition?
A: This may occur by electromagnetic interference, which is
normal.
Q: Why are there so many fault codes showing up?
A: This can happen if you have a poor connection or a
ground fault.
Q: Why can't I erase the DTCs?
A: Ensure that the malfunction related to the DTCs has been
properly fixed. Then, switch off the ignition. Wait for 1 to
3 minutes and start the vehicle. Try to run "Read Codes"
again and see if the issue was fixed. Some DTCs can only
be erased after you follow all of these steps.
Q: Can the AL500B test the battery installed in the vehicle?
A: Yes, this tool supports both in-vehicle and out-of-vehicle
testing.
Q: Which batteries can be tested by the AL500B?
A: The AL500B works on 12V regular flooded, AGM Flat Plate,
AGM Spiral, GEL and Deep Cycle batteries, with a CCA
between 100 to 2000.
70.87"
-10℃ to 50℃ (14 ℉ to 122 ℉ )
-20℃ to 70℃ (-4 ℉ to 158 ℉ )
7.32*3.74*1.34"
8.46 oz