Troubleshooting; Support - Franke FSM 97 P Mode D'emploi

3.
Refit the intermediate pane (marked with "1R")
before refitting the inside pane: To position the panes
of glass correctly, make sure that the "R" mark can be
seen in the left-hand corner�
First insert the long side of the glass indicated by "R"
into the support seats (a), then lower it into position
(b)�
Repeat this procedure for both panes of glass�
A
B

TROUBLESHOOTING

Problem
The oven does not work
The display shows the letter "F"
followed by a number

SUPPORT

In the event of any operation problems, contact a Franke
Technical Service Centre�
Never use the services of unauthorized technicians�
Specify:
- the type of fault
- the appliance model (art�/Code)
- the serial number (S�N�) on the rating plate, located
on the right hand edge of the oven cavity (visible
when the oven door is open)�
001
12
4.
positioning� Make sure the seal is secure before
refitting the door�
Possible cause
Power cut
Disconnection from the
mains
Software problem
When contacting our
Service Centre, please
state the codes provided
on your product's
identification plate�
Refit the upper edge: a click will indicate correct
Solution
Check for the presence of mains electrical
power and whether the oven is connected to
the electricity supply�
Turn off the oven and restart it to see if the
fault persists
Contact you nearest After-sales Service
Centre and state the letter or number that
follows the letter "F"
XXXXXXXXXX
XXXXXXXXXX
XXXXXXXXXX
XXXXXXXXXX
XXX X X X X X XXX XX XXXX X X X
XXXXXX XXXXXX XXXXX XXXXXXX
Model: xxxXXXXxx
XXXXXX