Roland JUNO-STAGE Mode D'emploi page 225

HGeneral Purpose Controller 7 (Controller number 82)
Status 2nd byte
BnH 52H
n = MIDI channel number:
vv = Control value:
HGeneral Purpose Controller 8 (Controller number 83)
Status 2nd byte
BnH 53H
n = MIDI channel number:
vv = Control value:
HPortamento control (Controller number 84)
Status 2nd byte
BnH 54H
n = MIDI channel number:
kk = source note number:
GProgram Change
Status 2nd byte
CnH ppH
n = MIDI channel number:
pp = Program number:
* These messages are transmitted when Patch, Rhythm Set or Performance is selected. But
not transmitted when Transmit Program Change parameter (SYSTEM/MIDI/TX) is
OFF.
* In Performance mode, these messages are not transmitted when External Program
Number parameter (PERFORMANCE/CONTROL/CTRL SW/EXT) is OFF.
GChannel Pressure
Status 2nd byte
DnH vvH
n = MIDI channel number:
vv = Channel Pressure:
GPitch Bend Change
Status 2nd byte
EnH llH
n = MIDI channel number:
mm, ll = Pitch Bend value:
IChannel Mode Messages
GMONO (Controller number 126)
Status 2nd byte
BnH 7EH
n = MIDI channel number:
mm = mono number:
GPOLY (Controller number 127)
Status 2nd byte
BnH 7FH
n = MIDI channel number: 0H - FH (ch.1 - 16)
3rd byte
vvH
0H - FH (ch.1 - 16)
00H - 7FH (0 - 127)
3rd byte
vvH
0H - FH (ch.1 - 16)
00H - 7FH (0 - 127)
3rd byte
kkH
0H - FH (ch.1 - 16)
00H - 7FH (0 - 127)
0H - FH (ch.1 - 16)
00H - 7FH (prog.1 - prog.128)
0H - FH (ch.1 - 16)
00H - 7FH (0 - 127)
3rd byte
mmH
0H - FH (ch.1 - 16)
00 00H - 40 00H - 7F 7FH (-8192 - 0 - +8191)
3rd byte
mmH
0H - FH (ch.1 - 16)
00H - 10H (0 - 16)
3rd byte
00H
ISystem Realtime Messages
* Sent when Sync Output parameter (SYSTEM/TEMPO/SYNC) is set to ON.
GTiming Clock
Status
F8H
GStart
Status
FAH
GContinue
Status
FBH
GStop
Status
FCH
GActive Sensing
Status
FEH
* This message is transmitted at intervals of approximately 250 msec.
* This message is not sent when Transmit Active Sensing parameter (SYSTEM/MIDI/TX)
is OFF.
ISystem Exclusive Messages
Universal Non-realtime System Exclusive Message" and Data Set 1 (DT1) are the only
System Exclusive messages transmitted by the JUNO-STAGE.
GUniversal Non-realtime System Exclusive Message
HIdentity Reply Message (JUNO-STAGE)
Receiving Identity Request Message (p. 221), the JUNO-STAGE send this message.
Status Data byte
F0H 7EH, dev, 06H, 02H, 41H, 25H, 02H,
00H, 01H, 00H, 03H, 00H, 00H
Byte Explanation
F0H Exclusive status
7EH ID number (Universal Non-realtime Message)
dev Device ID (dev: 10H - 1FH)
06H Sub ID#1 (General Information)
02H Sub ID#2 (Identity Reply)
41H ID number (Roland)
25H 02H Device family code
00H 01H Device family number code
00H 03H 00H 00H Software revision level
F7H EOX (End of Exclusive)
Implémentation MIDI
Status
F7H
225