Hilti VC 60-U Mode D'emploi page 29

1. Disconnect the dust bag sleeve from the
hose socket.
2. Close the slider on the dust bag sleeve.
3. Clean the waste material container with a
cloth or hose it down with water.
4. Insert a new dust bag in the waste material
container.
en
5. Press the dust bag sleeve firmly onto the
hose socket.
7.5 Picking up liquids
NOTE
A fluted filter should always be fitted when the
appliance is used to pick up liquids (see "Care
and maintenance").
7.5.1 Before picking up liquids 5
1. Remove the dust bag / disposal bag from
the waste material container.
2. Check the electrodes / level monitoring
float to ensure that the parts are clean and
operating smoothly. Clean the parts with a
brush if necessary.
3. Deactivate the automatic filter cleaning
system.
7.5.2 When picking up liquids
If possible, use a separate fluted filter for pick-
ing up liquids.
The appliance switches itself off automatically
when the liquid in the container reaches the
maximum level.
WARNING
If foaming occurs, switch the appliance off
immediately and empty the container.
7.5.3 After picking up liquids
1. Empty the waste material container and
clean it out by hosing it down with water,
clean the float, clean the electrodes with a
brush and clean the filter element by wiping
it with the hand after first allowing it to dry.
2. Leave the vacuum cleaner top section and
the container standing separately. This will
allow the fluted filter and the container to
dry.
7.6 After finishing work
1. Switch the appliance off.
2. Disconnect the supply cord plug from the
power outlet.
26
Printed: 05.01.2017 | Doc-Nr: PUB / 5323628 / 000 / 00
3. Roll up the supply cord and hang it on the
hook.
4. Empty the container and clean the appli-
ance by wiping it with a damp cloth.
5. Roll up the suction hose.
6. Store the appliance in a secure, dry place
where it is inaccessible to unauthorized
users.
7.7 Emptying the waste material container
7.7.1 Emptying dry dust from the waste
material container
DANGER
Check that the bag has not been pierced
through by objects which may cause injury.
NOTE
It is recommended that the filter is cleaned
thoroughly before emptying the waste material
container when it contains dry dust. This will
increase the life of the filter significantly.
7.7.1.1 Before emptying the waste
material container, proceed as
follows:
1. Engage the castor brakes.
2. Disconnect the supply cord plug from the
power outlet.
3. Open the two catches.
4. Lift the vacuum cleaner top section away
from the waste material container and
place it on a level surface.
7.7.1.2 After emptying the waste material
container, proceed as follows:
CAUTION
When fitting the top section of the vacuum
cleaner, take care to avoid pinching your
fingers or damaging the supply cord.
1. Fit the vacuum cleaner top section onto
the waste material container and close the
two catches.
2. Fit the suction hose securely in the hose
socket.