Mounting The Access Point On A Support - Cisco Aironet 1300 Serie Instructions De Montage

Mounting the Access Point on a Support

This warning applies to outdoor installations:
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Statement 1030
To attach the access point to a support, follow these steps:
Mount the housing bracket to the mounting bracket by sliding the hang pins on the housing bracket into
Step 1
the hang pin slots on the mounting bracket. The connectors should face downward (See
Figure 13
1 Hex bolt with serrated flange and washer (4 locations)
Step 2 Secure the housing bracket to the support bracket with four hex bolts and flat washers.
Note
Roughly position the integrated antenna by pointing the flat face of the access point toward the site of
Step 3
the remote access point.
After aligning the antenna, tighten all mounting bolts to 6 to 10 ft-lbs.
Step 4
78-17634-01B0
Mounting the Access Point to the Support
1 5
0
1 5
I S
T H
E
S I D
U P
If you are using the integrated antenna, loosely tighten the U bolts so you can adjust the access
point horizontally for antenna positioning.
Cisco Aironet 1300 Series Lightweight Outdoor Access Point Mounting Instructions
Mounting the Access Point
1
1
Figure 13).
33