Cisco Aironet 1300 Serie Instructions De Montage page 24

Mounting the Access Point
Mounting the Access Point
To mount the access point on the mast, follow these steps:
Step 1 Attach the access point near the top of the mast.
If the mast is the same diameter as the rooftop support, you can use the supplied hardware. The mounting
brackets accommodate a small mast (see
Mounting Hardware" section on page
Figure 6
1
1
1
U bolt (2 supplied)
Step 2 Connect the ground lug on the access point to the mast using #6 gauge wire. Use a crimping tool to secure
the wire to the ground lug. Use a mast clamp or tapped screws into the mast for the mast connections.
Cisco Aironet 1300 Series Lightweight Outdoor Access Point Mounting Instructions
24
Access Point Attached to a Small Mounting Pole
0
1 5
I S
T H
E
S I D
U P
2
Figure 6). For more information, see the
28.
1 5
2
Small mast, 1.25 to 2.5 inches
(30.5 to 63.5 mm) in diameter
"Assembling the
78-17634-01B0