Attaching The Mounting Bracket - Cisco Aironet 1300 Serie Instructions De Montage

Figure 11
1
1
1
Threaded mounting studs for the ground lug
Attach the supplied ground lug to the two threaded mounting studs on the access point using the two
Step 4
supplied locking Hex nuts. Torque the nuts to 10 to 12 in-lb.
Note
Note

Attaching the Mounting Bracket

The mounting bracket is suitable for rooftop, mast, or tower supports. How you attach the mounting
bracket to the support depends on the mast diameter, as follows:
Mast Type
Rooftop support
or small mast
78-17634-01B0
Ground Lug Attachment Point
Do not remove the two factory installed lock nuts on the mounting studs.
After you install the access point on its support, connect this ground to the building ground using
6 AWG wire.
Mast Diameter
1.25 to 2.75 in.
(30.5 to 69.9 mm)
Cisco Aironet 1300 Series Lightweight Outdoor Access Point Mounting Instructions
Mast Attachment
Attach the mast to the mounting bracket between the
bracket and access point (see
Mounting the Access Point
Figure 12)
31