Rooftop Or Wall Mount - Cisco Aironet 1300 Serie Instructions De Montage

The following hardware used to mount the power injector on the access point is supplied with the wall
or ceiling mounting bracket kit:
Four hex head bolts with serrated flange (M6x1x10 mm)
•
Four washers
•
Two short sub-mini RG-59 coax cables (12 in.)
•
Tighten the bolts to secure the power injector to the access point. Torque bolts to 6 to 8 ft-lbs.
Connecting the Cables
This procedure explains how to connect the cables and how to ground the access point:
Connect the two short coax cables to the power injector and to the access point.
Step 1
Caution
Find the building's grounding electrode system and then connect the access point ground lug to it using
Step 2
6 AWG copper wire. Use a crimping tool to crimp the wire to the ground lug. For more information about
attaching the ground lug to the access point, see
to the Access Point" section on page
This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the
Warning
absence of a suitably installed ground conductor. Contact the appropriate electrical inspection
authority or an electrician if you are uncertain that suitable grounding is available. Statement 1024
Note

Rooftop or Wall Mount

The mounting kit has a rooftop mounting bracket that is suitable for flat roofs, sloping roofs, and outdoor
walls. Mounting the access point on a rooftop or wall includes the following subtasks:
Mounting the access point
1.
Routing the cables
2.
This warning applies to outdoor installations.
Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
78-17634-01B0
To prevent damage to the access point or power injector, connect all coax cables from the
power injector to the access point and connect the power jack to the power injector before
applying power.
The grounding block and grounding wire are not required when mounting both the access point
and the antenna in a sheltered indoor environment.
Cisco Aironet 1300 Series Lightweight Outdoor Access Point Mounting Instructions
Step 3 and Step 4
30. See Figure 11 for the ground lug location.
Mounting the Access Point
in the "Attaching the Housing Bracket
17