Mounting the Access Point
Rooftop Support or Small Mast Diameters
Use this procedure to attach the mounting bracket to the rooftop support or to a mast with a diameter
between 1.25 and 2.75 inches (30.5 to 69.9 mm). For masts other than the rooftop support, use U bolts
that fit the mast in use.
To attach the mounting bracket to the rooftop support or small mast, follow these steps:
Position the mounting bracket next to the mounting pole so that the arrow on the bracket points up.
Step 1
Figure 12
1
6
1
U bolt
2
Mounting bracket
3
Flat washer
Step 2
Attach the mounting bracket to the mast using two U bolts and four nuts and washers.
Note
Cisco Aironet 1300 Series Lightweight Outdoor Access Point Mounting Instructions
32
Mounting Bracket Assembly for Rooftop Support
1 5
0
1 5
M O
U N
U P
T
5
If you are using the integrated antenna, loosely tighten the U bolts so you can adjust the access
point horizontally for antenna positioning.
2
3
4
4
Hex nut
5
Roof mounting mast
6
Hang pin slot
78-17634-01B0