Required Tools and Fasteners
This section describes the required tools, cables, and fasteners.
Tools
Mounting the access point requires the following tools:
7-mm, 8-mm, and 13-mm wrench or socket for mult-function mount
•
Two 7/16 wrenches or sockets for roof mount
•
Crimping tool for F-connectors that accommodates RG6/U cable (www.tessco.com)
•
Crimping tool for ground lug, Panduit CT-1004 or equivalent
•
(http://panduit.com/Products/ProductOverviews/index.htm)
You may also require tools for user-supplied hardware or fasteners.
Cables
Cisco recommends the following types of coaxial cable for the access point-to-power injector
connections:
Table 1
Cable Type
RG6
RG59/U
RG59/U
RG11/U
Fasteners
Identify requirements for special hardware or fasteners that are not supplied in the installation kit. For
example, it might be necessary to secure the access point to an unusually large-diameter pipe or
odd-shaped structural member that the supplied mounting bracket cannot accommodate.
The rooftop or wall mounting bracket requires the following user-provided fasteners:
Wooden structure—four 1/4 x 1 inch (minimum) lag bolts
•
Hollow walls—four 1/4-20 x 2 3/4 molly anchors
•
Concrete structure—four 1/4 x 1 3/4 inch (minimum) bolts with concrete anchors
•
The wall or ceiling mounting bracket requires the following user-provided fasteners:
•
Wooden structure—three 1/4 x 1 inch (minimum) lag bolts
Hollow walls—three 1/4-20 x 2 3/4 molly anchors
•
Concrete structure—three 1/4 x 1 3/4 inch (minimum) bolts with concrete anchors
•
For the user-provided fasteners, you must use the appropriate drill size recommended by your fastener
Note
vendor.
78-17634-01B0
Recommended Coaxial Cable Types
Belden Part #
Times Fiber Part #
9077
2360-T660-VB or
2560-T690-VB
1426A
02345-T5953-VB
1505A
02183-T5967-VB
8213
02362-T1153-VB
Cisco Aironet 1300 Series Lightweight Outdoor Access Point Mounting Instructions
Mounting the Access Point
Channel Master Part #
9539
9540
–
–
13