Cisco Aironet 1300 Serie Instructions De Montage page 29

Figure 9
1
1 Long flanged hex bolt
2 Carriage bolt
Align the holes in the mast pipe with the holes in the base plate.
Step 3
Step 4 Insert the long flanged hex bolt and washer into the upper holes on the base plate and through the mast
pipe (see
Step 5 Place a washer and hex nut on the end of the long flanged hex bolt and hand-tighten.
Position the mast pipe and base plate as shown in
Step 6
Align the lower square hole in the mast pipe with the semi-circular cut-out on the base plate.
Step 7
Place the carriage bolt into the square hole on the inside of the mast pipe.
Step 8
Place a washer and hex nut on the end of the carriage bolt and hand-tighten.
Step 9
Step 10 Repeat Steps 8 and 9 for the other square hole.
You have completed the assembly of your rooftop or wall mount. To mount your rooftop or wall mount,
please refer the
78-17634-01B0
Rooftop Support Bolt Locations
3
2
Figure 9).
"Mounting the Access Point" section on page
Cisco Aironet 1300 Series Lightweight Outdoor Access Point Mounting Instructions
3 Carriage bolt
Figure 9.
12.
Mounting the Access Point
29