Scrapping; Environmental Information - TECO 36 Special Manuel D'utilisation

To keep the machine in optimal conditions of safety and operation, the employer
must have the following periodic checks performed by the authorized service
network.
Periodic checks
a. periodic check of inflation pressure gauge every 2 years
b. periodic check of the inflation pressure relief valve every 2 years
c. periodic check of the regulator filter of the pneumatic supply at the machine inlet every
2 years
d. periodic check of the functionality of all the machine controls every 2 years
e. periodic check of the maximum pressure relief valve mounted on the tanks every 2
years
f. check of some parts of the machine such as: safety and protection devices, parts subject
to wear, parts subject to pressurized fluids (tanks, connections, pipes, etc.), electrical con-
nections etc.

12. SCRAPPING

If the equipment is to be scrapped, sort all electrical, electronic, iron and plastic components.
Dispose of the components separately in compliance with local regulations.

13. ENVIRONMENTAL INFORMATION

The disposal procedure described below only applies to equipment with the barred bin symbol
on the rating plate
This product may contain substances that are potentially harmful to the environment and
human health unless disposed of properly.
The information provided below is intended to prevent these substances from being released
into the environment, and to improve the use of natural resources.
This product may contain substances that are potentially harmful to the environment and
human health unless disposed of properly.
The information provided below is intended to prevent these substances from being released
into the environment, and to improve the use of natural resources.
Electrical and electronic equipment must never be disposed of in the usual municipal waste
but must be separately collected for proper treatment.
The barred bin symbol affixed on the product and shown in this page is meant to remind users
that the product must be disposed of properly at the end of its life cycle.
This prevents the inappropriate disposal of the substances contained in this product, or the
improper use of parts of this product, and the resulting hazards for the environment and human
health. It also helps to ensure that many materials contained in this product are recovered,
recycled and reused.
User's manual
WARNING
.
EN
109