Chapter 11 - Lay-Offs / Scrapping - TECO 302 Série Traduction Des Instructions Originales

The lift does not lower
smoothly
Lifting is not synchronized
The lift does not stop at
safety height
The motor does not stop
when the lift reaches it
maximum height

CHaPTEr 11 - LaY-oFFS / SCraPPiNG

If the lift is to be out of use for a long period, disconnect the energy supplies, empty the tank(s)
containing operating liquids and protect any parts which might be damaged by dust.
If the lift is to be decommissioned, it must be made unusable by removing the control unit com-
ponents (the hydraulic pump and electric motor) from the control unit.
All parts which might be sources of danger must be rendered harmless.
Assess the lift's category in relation to waste disposal.
Scrap as metal or electronic waste, consigning the various parts of the lift to the appropriate col-
lection centres.
If the lift is classified as special waste, dismantle it and subdivide its parts by type, then dispose
of them as required by law.
This product can contain substances that can be hazardous for the environment and for human
health if not disposed of appropriately
Therefore, follow the instructions below to avoid releasing these substances and to improve the
use of natural resources.
Electrical and electronic equipment must not be disposed of together with the normal urban wastes.
On the contrary, they must be sent to the selective waste collection for their correct treatment.
The crossed-out bin symbol, placed on the product and on this page, reminds the user that the
product must be disposed of properly at the end of its life. This prevents the inappropriate dis-
posal of the substances which this product contains, or the improper use of some of them, from
having hazardous consequences for the environment and human health. Furthermore, this helps
to recover, recycle and reuse many of the materials contained in these products.
For this purpose, producers and distributors of electrical equipment organise adequate collection
and disposal systems for the equipment itself.
At the end of the product life, contact your distributor for further information on the collection
134
Air in the hydraulic system Bleed the hydraulic system.
Leakage or air in the hydrau-
lic system
The safety height limit
switch does not work
The maximum height limit
switch does not work
LaY-oFFS
SCraPPiNG
Environmental information
Bleed the hydraulic system.
Check the limit switch and
replace if needed.
Check the limit switch and
replace if needed.
Operator's m anual