TECO 36 Special Manuel D'utilisation page 102

If necessary:
a. Continue inflating up to the maximum value of 3.5 bar to position the tyre correctly on
the rim. Avoid distractions during this operation, and continually check tyre pressure on
the air pressure gauge to prevent excessive inflation. Inflating tubeless tyres requires
a larger air flow to force the beads past the HUMP rim - see rim profiles for mounting
tubeless tyres.
b. Check that the beads are correctly inserted in the rim; otherwise, deflate the tyre,
break the beads as described in the relevant section, lubricate and turn the tyre on the
rim. Repeat the mounting operation described previously and check again.
Risk of explosion. During the bead insertion phase, do not exceed the maximum
pressure indicated by the manufacturer on the sidewall of the tyre.
- Once the bead has been inserted, refit the internal part of
the valve and then inflate the tyre to the pressure indicated
by the vehicle manufacturer.
- If the tyre is excessively inflated, the air can be released by
pressing the brass manual deflation button located below the
air pressure gauge (Fig.33).
- Disconnect inflation hose from valve rod.
- Take the operating arms to the "non -" position.
- Remove the wheel from the tyre changer.
9.7.c. SPECIAL PROCEDURE (TI VERSION)
The TI version facilitates bead insertion and inflation of Tubeless tyres through the emis-
sion of a strong jet of air from the nozzles placed near the locking wedges.
102
30
WARNING
31
32
B
33
User's manual