Check that the lubrication cup (B, Fig. 2a) contains
lubricating oil; top up is necessary. Use SAE20 oil.
The pneumatic supply inlet point, in the workshop line,
must be equipped with a pneumatic supply shut-off
valve, placed upstream the filter/regulator unit sup-
plied with the machine (B Fig. 2a).
Before proceeding with the electrical and
pneumatic connection and whenever the
electrical and pneumatic power supply
is restored, make sure that the machine
is in the configuration described below:
- pedal A COMPLETELY LOW (turntable
closed).
- pedal B COMPLETELY LOW (pole not
tilted).
1.2.e TECHNICAL DATA
- Table top clamping capacity (tyre changer 10"-25"):
• inside clamping .............................................................................................. 13"-25"
• outside clamping ............................................................................................10"-22''
- Rim width ..............................................................................................370 mm (14,5")
- Maximum tyre diameter: .....................................................................1060 mm (41,5")
- Bead breaking pressure: .................................................................................2900 Kg
- Air pressure: ....................................................................................................8-10 Bar
- Motor electrical features:
• 1ph version - 1 speed 240V - 50Hz ...................................................... 6A - 0,75 kW
• 3ph version - 1 speed 230V - 50Hz ................................................... 2,8A - 0,55 kW
• 3ph version - 1 speed 400V - 50Hz ................................................... 1,6A - 0,55 kW
• 3ph version - 2 speed 230V - 50Hz ......................................... 5,3/6,8A - 0,8/1,1 kW
• 3ph version - 2 speed 400V - 50Hz ......................................... 2,8/4,4A - 1,1/1,5 kW
• 1ph version - 2 speed 200-230V - 50Hz (Motoinverter) ............................. 0.75 kW
76
DANGER
B
A
B
2a
User's manual