TECO 36 Special Manuel D'utilisation page 85

Install the tyre changer in the chosen work posi-
tion, complying with the minimum clearances
shown in fig.8.
The support surface must have a load-bearing
capacity of at least 1000 kg/m
Ambient working conditions
- Relative humidity 30% ÷ 95% without conden-
sation.
- Temperature 0°C ÷ 50°C.
Whenever the machine is disconnected from the pneumatic line for long periods,
before restoring the pneumatic supply, check the configuration of the pedals
as shown below.
Before proceeding with the electrical and
pneumatic connection and whenever the
electrical and pneumatic power supply
is restored, make sure that the machine
is in the configuration described below:
- pedal A COMPLETELY LOW (turntable
closed).
- pedal B COMPLETELY LOW (pole not
tilted).
User's manual
.
2
WARNING
DANGER
B
750
A
1000
8
EN
85