Maintenance - TECO 36 Special Manuel D'utilisation

11. MAINTENANCE

It is prohibited to perform any operation that changes the pre-set value of the pres-
sure regulation valve or pressure limiter. The manufacturer declines all liability for
damage resulting from tampering with such valves.
Before making any adjustments orcarrying out maintenance on the machine,
disconnect the electrical and compressed air supply and make sure that
all moving parts are locked in place.
Do not remove or modify any component of this machine (these operations
may only be carried out by technical assistance personnel).
When the machine is disconnected from the pneumatic power supply, the
pneumatic actuators can remain pressurized.
Before carrying out any regular maintenance operation or topping up with lubricant,
disconnect the machine from the compressed air supply line.
The manufacturer declines all responsibility for claims resulting from the use
of non-original spare parts or accessories.
- Regularly clean the machine from dirt
- Keep all guides clean and lubricated (vertical axis, horizontal axis, jaw guides)
- The purpose of the regulator filter and lubricator (FRL) unit is to filter the air, adjust the
pressure and lubricate it.
The "FRL" unit supports a maximum input pressure of 16 bar and has an adjustment
range between 0.5 to 10bar, this adjustment can be modified by pulling the handle to
the extracted position and turning it. At the end of the adjustment, return the handle to
the locked position pushing it downwards (fig.38a).
The lubricant flow rate adjustment is carried out by turning the screw on the element "L",
User's manual
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
EN
107