Additional Rim/Tyre Information - TECO 36 Special Manuel D'utilisation

1.2.f. AIR PRESSURE
The machine is equipped with an internal pressure limiting valve to minimize the risk of
over inflating the tyre.
1. Never exceed these pressure limitations:
• The supply circuit pressure (from the compressor) is 220 psi (16 bar).
• The operating pressure (indicated on the regulator) is 150 psi (10 bar).
• The tyre inflation pressure (displayed on the pressure gauge) must never exceed the
pressure indicated by the manufacturer on the sidewall of the tyre itself.
2. Activate the air inflation jets only when inserting the bead.
3. Fully bleed air pressure system before disconnecting power supply line or other
pneumatic components. Air is stored in a reservoir to operate the inflation jets.
4. Activate the air inflation jets only if the rim is correctly clamped on the tyre changer (if
required) and the tyre is completely mounted.

1.3. ADDITIONAL RIM/TYRE INFORMATION

Wheels equipped with pressure sensors and special rims or tyres could require
particular work procedures. Consult wheels and tyre manufacturer's service
manuals.
78
• RISK OF EXPLOSION
• Never exceed tyre pressure recommended by tyre
manufacturer.
• Always match the tyre and rim dimensions.
• Take care to avoid any damage to the tyre.
• During inflation, keep outside the vertical cylinder
area occupied by the wheel.
WARNING
DANGER
User's manual