TECO 36 Special Manuel D'utilisation page 103

Before starting with the operations described below, make sure there is no
dirt, dust or other impurities near the inflation nozzles. It is advisable to wear
protective goggles.
- Verify that both upper and lower tyre beads and
rim bead seat have been properly lubricated with
an approved mounting paste.
- Move the horizontal arm to the wheel centre (all
slipped off towards the operator)
- Make sure that the wheel is clamped to the turntable
from the inner side (fig.34).
- Lower the vertical arm until it touches the rim (fig.29), then clamp the arm in this position.
- Remove the valve core if it has not already been removed (Fig. 30).
- Connect the Doyfe connector of the inflating hose to the valve stem (Fig. 31).
To increase the effectiveness of the air jets, manually lubricate and lift the lower
bead before activating the nozzles.
- Fully press the inflation pedal for a short time (Fig. 35). The tyre will expand, and the
beads will seat.
To improve the operation of the tubeless tyre inflation system the line pressure
must be between 8 and 10 bar.
User's manual
WARNING
WARNING
35
WARNING
EN
34
36
103