TECO 36 Special Manuel D'utilisation page 96

9.5.b TOOL POSITIONING
- Press the pedal to move the column into its working position (Fig. 20a).
- Press the locking button into position A to contemporarily unlock working arm and
horizontal arm. The tool will move upwards in
its rest position (Fig. 22).
With the locking button in position B, the tool can move freely downwards up to the rim
edge or up to the minimum working height (Fig. 22). Press the locking button in position
C to contemporarily lock vertical and horizontal arms (Fig. 22). In this case the tool will
be automatically positioned at a security distance from the rim edge.
- Make the head go down on the rim (locking button in position B).
- For correct tool positioning, the insert (fig. 21a) must be at the end position with the
rim edge, where the vertical wall begins.
ATTENTION : Use the handle to achieve the correct tool positioning on the rim.
- Press locking button to fix the tool position.
A
The distance between rim and tool head will remain unchanged till the control
button is in locking position.The operator can tilt the vertical post (i.e. when
handling a set of tyres having same dimensions) without repositioning the tool
on the rim.
Risk of hand crushing between demounting / mounting tool and the wheel.
96
B
C
22
WARNING
WARNING
22a
User's manual