Operating Off--Aisle Wand (Option) - Tennant 5400 Opérateur Manuel Et Liste Des Piéces

ATTENTION: Do not allow foam or water to enter
float shut-off screen, vacuum motor damage will
result; not covered by warranty. Foam will not
activate float shut-off screen.
5. For heavily soiled areas, double scrubbing is
recommended. First scrub area with squeegee up,
let solution set for 3--5 minutes, then scrub area a
second time with squeegee down.
6. Disc Scrub Head: Change or turn pads over when
worn.
7. Cylindrical Brush Scrub Head: If you experience
excessive brush vibration or poor scrubbing
performance, see ADJUSTING SCRUB BRUSH.
8. If squeegee leaves streaks, raise and wipe blades
with a cloth. Pre-sweep area to prevent streaking.
9. Observe battery meter. When needle drops into
red zone, stop scrubbing and recharge batteries.
ATTENTION: Do not operate machine with battery
meter in red zone, battery damage will result.
WARNING: Fire Or Explosion Hazard. Do Not
Pick Up Flammable Materials Or Reactive Metals.
OPERATING OFF- -AISLE WAND (OPTION)
The off--aisle wand allows you to scrub areas that the
machine is unable to reach.
NOTE: The off- -aisle wand Option is not available for
FaST models.
1. Turn key to the off position and set parking brake,
if equipped.
FOR SAFETY: Before leaving or servicing
machine, stop on level surface, turn off machine,
and set parking brake, if equipped.
2. Connect solution hose to quick disconnect coupler
located behind right drive wheel (Figure 28).
FIG. 28
Tennant 5400 (04- -05)
Home Find... Go To..
3. Disconnect squeegee vacuum hose from
squeegee assembly and connect wand's vacuum
hose using hose adapter (Figure 29).
FIG. 29
4. Connect hoses to wand.
5. Turn key and wand switch to the on position
(Figure 30).
FIG. 30
6. Lower squeegee lever knob to activate vacuum
motor (Figure 31).
FIG. 31
OPERATION
15