Machine Jacking; Transporting Machine; Storing Machine; Freeze Protection - Tennant 5400 Opérateur Manuel Et Liste Des Piéces

OPERATION

MACHINE JACKING

Use designated locations under the solution tank for
jacking up machine. Use a piece of wood to distribute
machine weight load (Figure 74).
Always stop machine on a flat level surface and block
machine tires before jacking up machine.
FIG. 74
FOR SAFETY: When servicing machine, block
machine tires before jacking machine up.
FOR SAFETY: When servicing machine, jack
machine up at designated locations only. Block
machine up with jack stands.

TRANSPORTING MACHINE

When transporting machine by use of trailer or truck,
be certain to follow tie--down procedures below:
FOR SAFETY: When using machine, go slow on
inclines and slippery surfaces.
1. Raise squeegee and scrub head.
2. Load machine using a recommended loading
ramp.
3. Position front of machine up against front of trailer
or truck. Once machine is positioned, lower scrub
head and squeegee.
4. Set parking brake, if equipped, and place a block
behind each drive wheel to prevent machine from
rolling.
28
Home Find... Go To..
5. Secure machine using tie-down brackets located
at rear of machine frame, if equipped. It may be
necessary to install tie--down brackets to the floor
of your trailer or truck.
6. Place tie--down straps over top of machine to
prevent it from tipping.
NOTE: Do not use control grips to secure machine for
transporting.
FOR SAFETY: When transporting machine, use a
recommended ramp when loading/unloading
on/off truck or trailer. Use tie- -down straps to
secure machine to truck or trailer.

STORING MACHINE

1. Charge batteries before storing. Never store
machine with discharged batteries.
2. Drain and rinse tanks thoroughly.
3. Store machine in a dry area with squeegee and
scrub head in the raised position.
4. Remove recovery tank lid to promote air
circulation.
ATTENTION: Do not expose machine to rain; store
indoors.

FREEZE PROTECTION

1. Be sure the solution tank and recovery tank are
empty.
2. Pour 3.8 L of pre--mixed automotive--type
windshield washer solution into the solution tank.
3. Turn the machine power on.
4. Start the solution flow.
5. The washer solution does not need to be drained
from the solution tank.
Tennant 5400 (05- -03)