Machine Maintenance; Daily Maintenance - Tennant 5400 Opérateur Manuel Et Liste Des Piéces

6. After charging, check the electrolyte level (A)
again. The level should be approximately 1 cm
(0.38 in) from the bottom of the fill--port (B) (Figure
56). Add distilled water if needed. DO NOT
OVERFILL.
B
A

MACHINE MAINTENANCE

To keep machine in good working condition, simply
follow daily, weekly and monthly maintenance
procedures.
FOR SAFETY: Before leaving or servicing
machine, stop on level surface, turn off machine,
and set parking brake, if equipped.
WARNING: Electrical Hazard. Disconnect
Battery Cables Before Servicing Machine.
ATTENTION: Contact an Authorized Service
Center for machine repairs. Machine repairs
performed by other than an authorized person will
void your warranty.

DAILY MAINTENANCE

(After Every Use)
1. Drain and flush out tanks with clean water
(Figure 57).
FIG. 57
Tennant 5400 (04- -05)
FIG. 56
Home Find... Go To..
2. Remove recovery tank plug and flush intake
opening with water (Figure 58).
FIG. 58
3. FaST Model Only: When FaST--PAK carton is not
installed on machine, make sure that the supply
hose is connected the hose storing plug. This will
prevent the FaST solution system from drying out
and clogging up (Figure 59). If any dried
concentrate is visible on the FaST--PAK connector
or the supply hose connector, soak in warm water
to remove.
FIG. 59
4. Remove and rinse float shut-off screen located in
recovery tank (Figure 60).
FIG. 60
5. Cylindrical brush scrub head: Empty and rinse
debris trough (Figure 61).
OPERATION
23