Machine Setup; Attaching Squeegee Assembly; Installing Brushes/Pads (Disc Scrub Head Model) - Tennant 5400 Opérateur Manuel Et Liste Des Piéces

MACHINE SETUP

ATTACHING SQUEEGEE ASSEMBLY

1. Turn key to the off position.
FOR SAFETY: Before leaving or servicing
machine, stop on level surface, turn off machine,
and set parking brake, if equipped.
2. Raise squeegee mount bracket using squeegee lift
lever (Figure 3).
FIG. 3
3. Loosen two thumb knobs on squeegee and slide
squeegee into slots of squeegee mount bracket.
Tighten thumb knobs securely (Figure 4).
FIG. 4
4. Connect the vacuum hose to the squeegee
assembly. Loop the hose as shown using the hose
clip provided (Figure 5).
Tennant 5400 (04- -05)
Home Find... Go To..
FIG. 5
INSTALLING BRUSHES/PADS
(Disc Scrub Head Model)
NOTE: Consult an authorized distributor for pad/brush
recommendations.
1. Press bottom half of brush pressure switch until
scrub head is completely raised (Figure 6).
FIG. 6
2. Turn key to the off position.
FOR SAFETY: Before leaving or servicing
machine, stop on level surface, turn off machine,
and set parking brake, if equipped.
3. Attach pads to pad drivers before installing
drivers. Secure pad with centerlock (Figure 7).
FIG. 7
OPERATION
9