Possible Malfunctions - Bartscher VAK 100 300741 Mode D'emploi

Storage of the vacuum packing machine
o Prior to storing the device in a dry place, ensure that it has been cleaned in
accordance with the manufacturer's instructions.
o Ensure that no foreign objects are found on the pressing seal and the sealing strip.
Never place heavy objects on the vacuum packing machine .
o The vacuum packing machine must be stored on flat and safe surface, in an area
inaccessible to children.
CAUTION!
Always store the vacuum packing machine with opened cover after packing;
never lock the closed cover, as it will deform the seals and prevent correct
operation of the vacuum packing machine .

7. Possible Malfunctions

In case of malfunction or damages contact the professional shop or our service
department. Inspect the device for the malfunctions described below.
Problem
The device does
not work
The device does
not seal the first
weld on the bag
cut from the roll
The device does not
produce complete
vacuum in the bags
- 50 -
Possible cause and solution
Check if the supply plug is correctly connected to the socket.
Check the socket by connecting another device.
Check the supply cable and plug for the damages. In case
of their damage do not use the device. Contact the service
company.
Check correct bag position according to section:
5.5.4 "Preparation of film roll bags"
Check if the pressing seal is in correct position and not
damaged.
In order to correctly seal the open bag end must be placed
in the vacuum chamber on its whole length.
Check the sealing strip, pressing seal, and other seals for
contamination. Clean the and install in appropriate position
when required.
The vacuum packing bag may be punctured. To check it,
seal the bag with some air inside, immerse in water and
squeeze. Air bubbles indicate that the bag is not tight. Seal
the bag again or use another one.