Operation With Material Lifting Equipment; Manual Safety-Stop; Securing The Load; Immediate Measures After A Safety-Stop - Tractel Blocstop BSO 500 Serie Manuel D'installation Et De Manutention Original

Installation and operating manual
See Fig. 9 (example).
– Open the fall arrest device: Turn the manual lever (2) clock-
wise until it latches into place.
– Start the hoisting gear.
– Check the inspection window (4) during every run to see
whether the centrifugal force weight is turning.
Note:
Where possible perform this check when beginning to move and
before the load lifting equipment has reached a great height.
If the centrifugal force weight does not turn:
– Immediately stop the load lifting equipment.
– Observe the operator's emergency plan.
– Remove the fall arrest device and send it to TRACTEL
Greifzug GmbH or an authorized hoisting gear workshop for
inspection.
Safety rope is not tensioned
If the safety rope is not under tension when the fall arrest device
is closed:
– Stop the hoisting gear.
– Check whether the safety rope is hanging free.
– Open the fall arrest device: Turn the manual lever (2) clock-
wise until it latches into place.
– Re-tighten the safety rope by hand, if necessary.
– Only continue with the original movement after the safety
rope has been re-tensioned.
11.3 Operation with material lifting
equipment
See Fig. 9 (example).
– Open the fall arrest device: Turn the manual lever (2) clock-
wise until it latches into place.
– Start the hoisting gear.
– Check the inspection window (4) during every run to see
whether the centrifugal force weight is turning.
If the centrifugal force weight does not turn:
– Immediately stop the load lifting equipment.
– Remove the fall arrest device and send it to TRACTEL
Greifzug GmbH or an authorized hoisting gear workshop for
inspection.
Safety rope is not tensioned
If the safety rope is not under tension when the fall arrest device
is closed:
– Stop the hoisting gear.
– Check whether the safety rope is hanging free.
EN-12
– Open the fall arrest device: Turn the manual lever (2) clock-
wise until it latches into place.
– Re-tighten the safety rope by hand, if necessary.
– Only continue with the original movement after the safety
rope has been re-tensioned.

11.4 Manual SAFETY-STOP

Press the SAFETY-STOP button to manually trigger the fall
arrest device in an emergency situation.

11.5 Securing the load

The fall arrest device can be used to secure the load during work
breaks. This relieves the strain on the rope hoist gearbox,
for example.
Note:
– Please follow the operator's work instructions and safety
measures and the notes in the operating manuals for the
hoisting gear and load lifting equipment.
See Fig. 9 (example).
Securing the load:
– Trigger the fall arrest device via the SAFETY-STOP button.
Re-open the fall arrest device:
– Move upwards slightly to reduce the strain on the rope.
– Open the fall arrest device: Turn the manual lever (2) clock-
wise until it latches into place.
– Re-tighten the safety rope by hand, if necessary.
– Only continue with the original movement after the safety
rope has been re-tensioned.
12 Immediate measures after a
safety-stop
A safety-stop means that the fall arrest device was triggered by a
hoist malfunction or suspension rope breakage, for example.
12.1 Safety-stop when using man riding
equipment
DANGER!
Danger of severe injuries caused by incorrect proce-
dures!
– Keep calm.
– Check out the cause.
– Eliminate the problem.
G905.11 - 01/2015