blockages and malfunction procedures). Merely handing this
manual over to the operator is insufficient.
–
Instructions regarding the maintenance of the product and
its accessories must be integrated in the system's mainte-
nance manual.
3
Overview
3.1
Delivery state
The equipment is delivered fully assembled.
3.2
Scope of delivery
Fall arrest device blocstop™ BSO
or
blocstop™ BSO (series BSO 1000 EFA) fall arrest device
with remote activation
Tractel
rope in accordance with the order specifications
®
Original Installation and operating manual
Logbook
Test certificate
CE Declaration of Conformity
Optional scope of delivery:
Lanyards
3.3
Equipment description
Authorized utilization
The fall arrest device blocstop™ BSO fitted with an automatic
sudden acceleration controller can be used with any hoisting
gear / load lifting equipment. The device has not been designed
for private use. The precise intended use will be defined by the
operator or the equipment manufacturer.
A fall arrest device is a safety component in accordance with the
Machine Directive 2006/42/EC, Appendix V. Safety components
are regarded as machines.
The fall arrest device must only be used with an original rope
with the rope diameter specified in this manual (see also name-
plate).
With the execption of the fall arrest device blocstop™ BSO 510,
all of the equipment described here can be used as a fall arrest
device for material handling and man riding equipment, see table
1 on page II.
The BSO 510 fall arrest device may only be used to hold material.
G905.11 - 01/2015
Maintenance and repair work must only be undertaken by author-
ized service personnel, see ' 16.1 Authorized maintenance per-
sonnel' on page 15.
TRACTEL Greifzug GmbH declares that the machine described
in this instruction manual complies with technological safety
standards that were applicable to the equipment in the European
Union when it was launched on the market by the manufacturer.
Commissioning the machine is prohibited until the machine in
which this is installed complies as a whole with the regulations of
the 2006/42/EC Directive, the corresponding national legislation
for implementing the regulations in accordance with national law
and the corresponding declaration of conformity has been issued.
The operator or system manufacturer must perform a risk
evaluation in accordance with Appendix I of the guideline
2006/42/EC for machines for raising loads. EN 14492-1
must also be taken into account when inspecting the equip-
ment.
A conformity evaluation process must be run by the operator
or the system manufacturer on machines used for man rid-
ing or man riding and material handling, which come under
Appendix IV No. 17 of Directive 2006/42/EC, in accordance
with Article 12, Paragraphs 3 or 4 of Directive 2006/42/EC.
EN 1808 must also be taken into account when inspecting
the equipment.
The fall arrest device must never be integrated in systems that
must comply with Directive 95/16/EC (Lift Directive, in Germany:
12 ProdSV).
BSO 1000 EFA type series with remote activation:
The remote activation of the BSO 1000 EFA type series is used
to activate the fall arrest device electrically e. g. using an addi-
tional pushbutton. The pushbutton can be integrated in the sys-
tem controller. Activation of the fall arrest device is also possible
by pressing the EMERGENCY-STOP button.
EFA fall arrest devices can also be used as a mechanical limiting
device for tilting, e. g. in conjunction with an electrical switch for
tilt monitoring.
The manufacturer of the overall equipment must carry out a risk
assessment according to EN ISO 12100:2010.
The additional risks that may occur from the remote activation
must be assessed for the application and eliminated using con-
structive measures. Additional risks are, amongst others:
The function of the magnetic cylinder is not wire-break proof.
Guarantee and liability exclusions
See ' 13 Foreseeable misuse' on page 14.
Any use other than that described here will be considered to be
unauthorized. TRACTEL Greifzug GmbH does not accept any
liability for damages resulting from unauthorized use. The opera-
tor must assume sole responsibility in this case. Abiding by all of
the instructions given in this instruction manual, in particular the
installation and maintenance regulations, are also considered
part of authorized use.
Installation and operating manual
EN-5