Ropes; Optional Accessories; Options; Necessary Accessories - Tractel tirak T 1000 Manuel D'installation Et De Manutention Original

Installation and operating manual
5

Ropes

General
DANGER!
Incorrect rope or rope with incorrect diameter!
Using an incorrect rope leads to a risk of falling or being in-
jured by falling objects and the risk of malfunctions!
– In order to operate safely only use original ropes author-
ized by TRACTEL Greifzug GmbH with the correct rope
diameter and the required design.
– If the load cannot be guided by on-site means then a low-
twist rope with a swivel hook or a rope swivel must be
used.
– The required rope diameter is listed in Table 1 on page II.
The design is listed in Table 7 on page 20.
The rope is included in the scope of delivery.
Alternative wire rope assemblies:
 End/thimble
 End/safety hook
6

Optional accessories

The following accessories can also be purchased:
Deflection roller

Adapter, eye hook or master link

Please directly contact TRACTEL Greifzug GmbH.
7

Options

Please directly contact TRACTEL Greifzug GmbH.
8

Necessary accessories

The following accessories, which are not part of scope of delivery,
are necessary to use the product:
Rigging and securing equipment with an adequate minimum

breaking strength (see 'Structural requirements' on Page 6).
If the rope is deflected or reeved: Rigging and securing

equipment with an adequate minimum breaking strength
(see '3.3 Equipment description, Structural requirements on
page 6).
A longer connecting cable can be used if necessary, see

'Electrical connection' on page 12.
Other original Greifzug accessories: See '6 Optional accessories'
on page 10.
The operator or the manufacturer of the system is responsible for
selecting and using the accessories in accordance with the local
EN-10
conditions. You must also abide by any other requirements of the
respectively applicable regulations and standards.
9

Installation and commissioning

9.1

Directives and standards

The product conforms with the following directives and standards:
Machine Directive 2006/42/EC

EN ISO 12100:2010

EN ISO 13849

EN 60204

Machines for lifting loads (transport of materials):

EN 14492-1:2006 + A1:2009
The safety goals required by Directive 2006/95/EC have

been complied with in accordance with Appendix I No. 1.5 of
the Directive 2006/42/EC.
The operator or the system manufacturer is responsible for en-
suring that the machine is used within the limits specified in these
instructions. The operator or the system manufacturer must also
observe the directives and standards for the machine in which
the unit will be fitted.
9.2 Checks to be undertaken before
starting installation
Check the rigging, deflection rollers and an-
choring points
– Check to ensure that the deflection roller, the rigging and
the on-site anchoring point all have the necessary minimum
breaking strength, see 'Structural requirements' on page 6.
Inspecting the installation site
General
– Check if other components obstruct a correct installation.
The installation space must not contain any sharp or edged
components.
– Check that the mounting does not cover any nameplates
(see Fig. 11).
If necessary provide for notches.
– Check whether a suitable connection for the power supply in
accordance with chapter 'Electrical connection' on page 12
is available on site.
Hoist
– Comply with the necessary installation space listed in Fig. 2
and Table 1 on Page II.
– Check to ensure that the rope enters the hoist vertically in
the pulling direction (Fig. 2).
G932.4 - 09/2015