Maintenance; 10.1 Service At The Air Intake Filter - Burkert 8690 Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Maintenance

10
mainTenance
The Pneumatic Control Unit is maintenance-free when operated
according to the instructions in this manual.
10.1 service at the air intake filter
Danger!
risk of injury from high pressure in the equipment/device.
▶ Before working on equipment or device, switch off the pressure
and deaerate/drain lines.
To protect the internal solenoid valves and the actuator, the pressure
supply air is filtered.
The direction of flow of the air intake filter in installed state is from
the inside to the outside through the filter material.
Quick plug-in
connector
O-ring
Air intake
filter
Fig. 22: Service on the air intake filter
Type 8690
procedure:
Unlock the quick plug-in connector by pressing the holding
element and pulling out the air intake filter (if necessary, use a
suitable tool in between the recesses in the head of the filter).
Clean the filter or, if necessary, replace the filter.
Check inner O-ring and, if required, clean.
Insert the air intake filter all the way into the quick plug-in
connector.
Danger!
risk of injury due to improper installation.
▶ Ensure that the air intake filter is installed correctly.
Check that the air intake filter is secure.
english
27

Publicité

Table des Matières
loading

Table des Matières