SICE S 63 Manuel D'instructions page 66

- Press the key
selection.
- Mount the specific extension on the inner
measuring arm, i.e. A if the weight-holder
device is not installed, B if the weight
holder device is installed (Fig. 17 a).
Remember to remove this extension before
performing the wheel spin.
- Set the wheel data as usual
- Proceed as described for dynamic balancing.
Motorcycle ALU programme
Proceed as follows to balance motorcycle
wheels dynamically using adhesive weights:
- Press the
LED corresponding to the programme
illuminates.
- Press the
"Motorcycle ALU" programme (the corre-
sponding balancing planes are highlighted
on the rim shown on the control panel).
- Proceed as described previously for the
"Motorcycle Dynamic" programme.
- For the application of the adhesive weight,
66
to confirm the
17a
keys until the
button twice to select
use 3 o'clock as a reference if the "H3"
configuration is active, 6 o'clock if the "H6"
configuration is active or 12 o'clock if the
"H12" configuration is active.
Best results can be achieved if the adhesive
weights are positioned with the outer edge
flush with the rim edge.
Split Weight programme (available
only with motorcycle programmes)
Some rims have spokes so wide that it is
not possible to place adhesive weights
next to them; a programme which divides
the counterweights into two parts has been
introduced to solve this problem.
In this case, when the centred position is
reached and it becomes obvious that the
balancing weight will have to be applied
in line with a spoke, proceed as follows:
- remain in the centred position;
- press ;
- use the
width of the spoke:
• 1 = small
• 2 = medium
• 3 = large
• OFF = deactivates the programme
- confirm with the
- apply two new counterweights in the
positions indicated.
In "MOTORCYCLE ALU" and "dynamic"
modes it is possible to divide the balancing
weights over both sides of the wheel to be
balanced.
keys to select the
key;
User manual S 63