SICE S 63 Manuel D'instructions page 46

- Fix the machine to the ground, fastening
the L brackets to the Fischers using the two
screws and the two washers (Fig. 6) on the
rear side and on the flange holder side.
Fitting the external sensor
(if present)
- Fasten the external sensor support to
the wheel balancer body using the three
screws supplied with the machine (A,
fig.6a);
- Insert the external sensor pin (B, fig.6a)
in the sensor support bush (C, fig.6a);
- Screw the screw (D, fig. 6a) bringing it closer
to the sensor pin without touching it;
- Make sure that the external sensor rotates
freely;
- Connect one of the sensor's cable connec-
tors to the socket located on the sensor
body (H, fig. 6b);
46
6
- Tape the cable to the sensor support (F,
fig. 6a) so that it is never tensioned;
- Connect the other sensor cable connector
to the machine's rear panel (G, fig. 6a);
- Fit the flange holder slides (5, Fig.7a),
position the balancing accessories in the
specific supports;
- Turn on the machine and make sure it
operates correctly.
IMPORTANT: after installing the external
sensor, calibrate the sensor as described in
the paragraph "Width sensor calibration".
Main working elements of the
(1) automatic diameter and distance meas-
uring arm
(2) automatic width measuring arm
(3) head
(4) display panel
(5) flange holder
(6) weight tray
(7) wheel support shaft
6a
(8) wheel guard
(9) wheel holder shaft locking brake
machine (fig. 7-7a)
User manual S 63
6b