WARNING
Problem: after PAX wheels have been selected the machine remains locked in this
function ..... it does not return to the status allowing work on wheels in INCHES.
Solution to problem ....
- the "wheel type" can only be selected if
- the wheel lift is in the rest (loading) position ...with microswitch tripped
- demount command not activated......it is of "dead-man" type, the contact has to remain
pressed down
- the PAX overlapping command must not be activated
- the tool head must be in the rest (fully retracted) position ....
NOTE for this last point:
If the machine still does not work after all the above conditions have been met, try moving the tool head to
the working position....
since there is no position microswitch, ...the circuit board does not recognise the precise
position, but it remembers the last command carried out.
Risk of crushing.
Never insert any part of the body, and in particular the hands,
between the bead breaker discs or demounting/mounting tools and
the wheel. Never insert any part of the body between the wheel
support and the tyre.
Never insert any part of the body between the wheel lift and other
elements with which it comes into contact. A beeper warns when it is
in operation.
NEVER stand behind the machine. Only one operator is authorised
to operate and use the machine.
Artiglio Master operator's manual
Key to danger warning decals
Risk of crushing.
EN
53