Switching The Infrared Controller; Dimming Function For The Infrared Heater/Infrared Plate - Sentiotec infrabox basic Instructions De Montage Et Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Instructions for use for the user
WARNING!
Risk of fire
● Before the infrared controller is switched on, make sure that no flam-
mable objects have been hung over the infrared heater or on the
infrared plate.

9.2. Switching the infrared controller

1. Press the ON/OFF switch 3, to switch on the infrared controller.
► The operating display 4 goes on.
2. Select the intensity of the function with the intensity selector 1 and 2.
► The infrared heater/the infrared plate begins to heat up.

9.3. Dimming function for the infrared heater/infrared plate

Controlling (dimming) the infrared heater/infrared plate is possible in 5 levels.
At 0 the infrared heater/infrared plate is switched off, at 5 it is a full capacity.
Function only possible in operating modes: leading edge phase control and
half-wave control
To activate the function, additional settings are required, see chapter 6.2. Operat-
ing type (infrared heater/infrared plate) on page 19
Function only possible in operating mode: normal and seat
To activate the function, additional settings are required, see chapter 6.1. Oper-
ating mode on page 18
1. Use the intensity selector 1 and 2 to set the preferred infrared heater/
infrared plate intensity.
► The infrared heater/infrared plate is switched on.
► The intensity display 5 lights up.
p. 28/32

Publicité

Table des Matières
loading

Table des Matières