Honda FF500 Manuel De L'utilisateur page 61

• Install the loading board straight and securely on the transport vehicle (e.g.
truck, etc.).
• Set the loading board parallel to the bed of the transport vehicle. Stand in
the center of the loading board width and be sure that the right and left rear
wheels of the tiller are parallel to the loading board.
• Do not release the clutch lever during loading/unloading. The tiller can make
abnormal movement when the clutch is released during loading/unloading.
• Move the gearshift lever to the ''TRANSPORT 1'' position and check that the
rotary is not turning before loading/unloading the tiller.
• Set the differential lock lever in the ''LOCK'' position.
• Set the gearshift lever in the ''FORWARD'' position for loading, and set the
lever in the ''REVERSE'' position for unloading.
• Start the engine and let it idle for 2 to 3 minutes before loading.
3. Secure the tiller to the bed by attaching rope to the handlebar and front guard
pipe as shown.
4. To prevent fuel spillage, drain the fuel from the carburetor (see page 59), make
sure that the fuel valve is in the OFF position, and keep tiller level.
58